OLO Jiggler Installer

BLE Mouse Jiggler With Display by Micromaker Labs

Installation Manual

1
Connect Board:
Plug the ESP32-C3 Super Mini into your computer.
2
Initialize:
Click 'Connect' in the Firmware Flasher box below.
3
Select Port:
Select the COM port labeled "USB Serial Device" or "CH343".
4
Install:
Click Install. Wait ~60s until the success message appears.
Firmware Flasher

Version: 1.0.0 | Board: ESP32-C3 Super Mini

Requires Web Serial API (Chrome/Edge)

Try The OLO Jiggler

Tap: Scroll  |  Hold: Select  |  Double Tap: Action

Hardware & Wiring Guide

Important: This firmware is strictly compiled for the ESP32-C3 Super Mini.

Wire your components exactly as listed below:

Component ESP32-C3 Super Mini Pin
0.96inch OLED SDAGPIO 20
0.96inch OLED SCLGPIO 21
Passive BuzzerGPIO 2
TTP233 SensorGPIO 1
Prerequisites
  • Browser: Chrome, Edge, Brave, or Opera on a desktop computer. Safari and Firefox do not support Web Serial.
  • Cable: A USB-C cable capable of data transfer (not just a charging cable).
  • Connectivity: Your host computer must have Bluetooth enabled to connect to the Jiggler once installed.